How to use a SF-95 Satellite Signal Finder:

Using a satellite signal finder / meter is simple.  We call these SF-95 signal meters an in-line meter.  Why?  Because as you can see in the diagram above, the meter is in the coaxial line between the satellite receiver and the dish / LNB.  The signal meter get's power from the satellite receiver, the same power that is used to give power to the LNBF in order for it to operate. 

You want to turn down the knob (counter-clockwise) on the front of the meter so that the signal indicating needle is balanced between 1 & 2.  Then start adjusting your dish until you get the signal locked in from the correct satellite.  Once you get the signal locked, the meter will buzz (tone) and go to 10.  Then turn down the knob some more so the needle goes back to 1 & 2 and adjust your dish slowly until you get more signal indication.  Keep repeating this step as needed until your satellite dish if fully peaked at the highest possible signal. 

SF 95 Signal Finder

Information Request SF95 Signal Finder Buy More, Save More Qty Price/pc 1-4 $12.99 5-9 $10.99 10-14 $9.99 15-19 $8.99 >19 $7.99

Use this miniature meter to easily align your satellite dish.  Great if you are planning to install a satellite motor.   SF-95 Satellite Signal Meter / Finder - SF-95c+ is a satellite finder that helps to make precise dish set-up easily.   Its ultimate sensitivity will indicate 0.2 dB level difference in 950 to 2050MHz.   SF-95 is miniature (3.03" x 2.36" x 1.10") and light weight (95 gm)   MODEL INPUT FREQ IMPEDANCE MIN. INPUT MAX. INPUT POWER SIZE SF-95c 950-2050 MHz 70 Ohm -40 dB m -10 dB m 13-18 V 77 x 60 x 28 mm     $7.50 $8.99 $16.99 $2.99 Surge Protector Add Now In-Line Amp Add Now Installation Kit Add Now Compass Add Now

 

Combine & Save <<<All This Only $34.99 1 DIYE Installation Kit 1 SF-95 Signal Finder 1 In-Line amplifier 1 Coaxial surge protector

Combine & Save 1 DIYE Installation Kit 1 SF-95 Signal Finder $25.00