|
Package #4 - FTA Motorized
Dish Kit |
|
|
|
Package #4
Buy More, Save
More |
|
Qty |
Price/set |
| 1-4 |
$119.00 |
|
5-9 |
$115.00 |
|
10-14 |
$109.00 |
|
15-19 |
$105.00 |
|
>19 |
$99.00 |
|
 |
|
Great for reception of
many satellites. Motor designed to follow the
satellite arch when installed properly and rotate
between different satellites.
 WS7630
Antenna - 76cm / 30inch offset satellite dish
with universal or tripod type mount.
Upgrade
to a Winegard Dish (optional)
TechSAT
Tracker LNBF - Standard Ku with super low noise
figure of 0.3dB or lower. The lower the noise
figure, the more stable your signal level.
SG2100
Motor - Powerful motor controlled by DiSEqC1.2
and USALS commands from the receiver. Does not
require extra wiring. Works with existing coaxial
cable (See
Diagram).
|
|
Motorized
Satellite Dish Package
This package is great for reception of most Ku band satellites.
Package comes with:
This is a great system for reception of almost all Ku band satellites
within N. America. The Ku dish is large enough to obtain signal
from many Ku band satellites. Below is a partial list of
the Ku band Linear / FSS satellites in N. America that you will be able
to pick up with this package:
| Color codes on this regional index: |
No
data/L/S/Ka band |
C band |
C & Ku band |
Ku band |
The dish motor, when installed properly, is designed to follow the
satellite arch from where all the satellites are located. The
motor installs based on your latitude. To get installation help
with installing a dish motor go
HERE.
This motorized antenna package works with any DiSEqC 1.2 receiver and
the HH motor mount is controlled via the satellite receiver with DiSEqC
protocol.
What is DiSEqC1.2?
DiSEqC stands for Digital Satellite Equipment Control. This not
only includes controlling via a dish motor, but also includes
controlling via a switch. DiSEqC1.2 is a command that is given to
the motor via the satellite receiver that tells the motor to turn right
or left.
We recommend you consider purchasing a SF95 signal finder. The use
of a signal finder when installing a motorized dish is made much
simpler. The signal finder is designed to buzz when you receive a
signal from a Ku or C band satellite. As you turn your satellite
motor east or west, and as you lock into different satellite signals,
the SF-95 signal meters beeps or buzzes to tell you that you have a
signal locked in. As you turn your dish east & west, if your
signal finder constantly goes off, then you know you are very close to
aligning your satellite dish to the satellite arch.
Satellite Arch & Satellite Locations
Here are the parts that are included in your dish motor:
Additional Part Recommendations for Easy Installation:
|
Inquire about this package |
|
|
|
